Product Category

Network Configurator


Programming Software for Creating Safety Circuits.

General Specifications
Japanese or English

Ver. 2.2[] or earlier
Windows 2000 Professional (Service Pack 4 or later)

Windows XP (Service Pack 2 or later, except for 64-bit version)

Windows Vista (Service Pack 1 or later, except for 64-bit version)

Ver. 3.30 or later

Windows XP (Service Pack 3 or later, except for 64-bit version)

Windows Vista (Service Pack 2 or later)

Windows 7

Ver. 3.4 or later

Windows XP Service Pack 3 (32-bit edition)

Windows Vista Service Pack 2 (32-bit edition,64-bit edition)

Windows 7 (32-bit edition, 64-bit edition)

Windows 8 (32-bit edition, 64-bit edition)

Windows 8.1 (32-bit edition, 64-bit edition)

Windows 10 (32-bit edition, 64-bit edition)

Note: Administrator rights are required for installation.
Main unit
Personal computer with processor recommended by Microsoft
Memory capacity recommended by Microsoft
Hard disk drive
At least 200 MB of hard disk space
SVGA (800 x 600 resolution) or higher with 256 colors minimum
Disk device
CD-ROM drive
Windows-supported mouse or other pointing devices
Communications port
One of the following communications port is required:
USB port: When using a USB port (USB 1.1) of NE1A-SCPU series or NE0A series to connect online

Ethernet port: When using Ethernet to connect online

DeviceNet interface card (3G8F7-DRM21 or 3G8E2-DRM21-EV1*): When using DeviceNet to connect online
Note: 1. PC cannot be put into a standby state with the NE1A series connected via USB cable.
DeviceNet interface card does not conform to 64-bit operating system.
           3. One or more USB port is required on a communications port of the maintenance tool.

* 3G8E2-DRM21-EV1 was discontinued at the end of March 2020.